ALFAMATIC CSQ-Visual, Руководство по установке, Страница: 7 / 16

7
Inputs terminal block (X3)
The inputs are optoinsulated and compatible with clean contact signals or 24 VDC PNP transistor
outputs.
Name Terminal Default
Input 0 X3.1 START
Input 8 X3.2
Input 1 X3.3 T.D.C.(1)
Input 9 X3.4
Input 2 X3.5
Input 3 X3.6
Input 4 X3.7
Input 5 X3.8
Input 6 X3.9
Input 7 X3.10
0VDC X3.11 Negative power supply
+24VDC X3.12 Positive power supply
(1) T.D.C. input in always on input 1.
The function of each input is configurable. Each input can have one of the following functions:
Name Default Function
START 0 Request for starting a new cycle. If remove the acquisition is stopped.
T.D.C.(1) 1 Signal "top dead center", used as a reset for a new cycle and ANDed with
the zero mark of the encoder to the zeroing the absolute position
JOB SELECTOR The binary value of these inputs select automatically a jobs (see 2).
PHASE SELECTOR The binary value of these inputs select automatically the phase of job.
BASKET 1 2 Input for sensor for the detection of normal rejected (basket)
BASKET 2 3 Input for sensor for the detection of special rejected (basket)
BASKET AUTO-CHECK Input for sensor for the detection of auto-check samples (basket)
RESET 2 Re-enable the instrument after a rejected
SESPEND ACQUIRE Suspends the acquisition of the curve useful in hydraulic presses in case
of stop in halfway.
ENABLE # See 2.4
TEST SIGNAL # #1=4 See 2.4
BOOSTER CYL BACK Used for the repetition of the working stroke
BOOSTER CYL END Used for the repetition of the working stroke
MAINTENANCE 5 Disable all controls
TABLE IN POS Signal for piece in the working position
IMPULSIVE START Left=6
Right=7
Request for start of a new cycle
NO EMERGENCY Machine is not in emergency
SAFETY Machine security (guards closed)
DRIVER ATIVATE Driver actived (servo presses)
IN POSITION Position reached (servo presses)
(1) T.D.C. input in always on input 1.