IN AN EMERGENCY
193
INFLATING PROCEDURE
– Place the wheel in the position illustrated
in the figure (
A-fig. 14
) for the operation
with the valve,
then engage the hand-
brake
.
– Screw the filling pipe (
B-fig. 15
) to
the bottle (
C
).
– Unscrew the tyre valve plug, remove the
element inside the valve by using the ap-
propriate tool (
D-fig. 16
); be careful not
to place it on the sand or on a dirty surface.
– Introduce the filling pipe (
B-fig. 17
)
in the tyre valve, keep the bottle (
C
) with
the pipe directed downwards, then press the
bottle so that the whole sealer can get into
the tyre.
– Screw again the element inside the
valve with the tool (
D-fig. 18
).
– Use the appropriate lever (
E-fig. 19
)
to insert and clamp the air compressor pipe
(
F
) to the tyre valve.
– Start the engine, insert the plug (
G-
fig. 20
) in the lighter (or current socket,
where fitted) and inflate the tyre according
to the right pressure value (see “Cold infla-
tion pressures” in the “Technical specifica-
tion”). You are advised to check the tyre
pressure value on the pressure gauge (
H-
fig. 19
) with the compressor off, in order
to have a more accurate reading.
If it is not possible to reach the prescribed
pressure, move the car forwards or back-
wards for about 10 metres, so that the seal-
er is distributed inside the tyre, then repeat
inflation.
If, in spite of the last operation, the pre-
scribed pressure is not achieved, do not
move the vehicle and contact Alfa Romeo
Authorized Services.
Once the correct tyre pressure has been
reached, start driving immediately so that
the sealer is distributed evenly inside the
tyre.
fig. 14
A0A0447m
fig. 15
A0A0378m
fig. 16
A0A0448m
Содержание Alfa 147 GTA
