8
-
It must be made of a material resistant to high temperatures, combustion product effects and corrosive effects of possible
condensation;
-
Predominantly vertical configuration without discrepancyon vertical angelslarger than 45°.
It is recommended that the base of the chimney is equipped with a collection chamber for solid materials or condensation (R). This chamber
must be equipped with the hermetic door (I).
Figure2.5:
smoke discharge with traditional chimney
It is recommended not to use exhaust pipes with internal diameter smaller than 100 mm.
In case the exhaust pipes have larger diameter, a steel pipe (A) must be inserted in the brick or concrete chimney (C), as depicted in Figure
2.6.
The steel pipe must be insulated by adequate material resistant to heat, such as stone wool or vermiculite (B), and it must be separated
from the outer part of the chimney.
Figure 2.6:
Exampleconnection to the chimney
In case of fire in the chimney or exhaust pipe immediately switch off the unit and disconnect it from the power supply
Unpacking and waste disposal
The packaging consists of non-toxic and non-hazardous materials. No special requirements needed for disposal. Disposal of the
remaining packaging is the responsibility of the user who must carry out the appropriate procedures for disposal in accordance with
applicable standards of the country in which the product is installed.
ATTENTION: Packing material must be kept out of reach for children without supervision or individuals with disabilities.
Electrical connection
The electrical connection to the network must be performed after the hydraulic connection.
Connect the product to household powerline.
Press the ON/OFF button, at the rear end of the unit, if you wish to turn the unit on. This way the unit is ready for ignition.
For further information see section 3.1.
