Alfa Network Color Tester, Техническое руководство

Страница: 41 / 45

Technical Manual
– Color Tester
EN TROUBLE SHOOTING
41
ERROR
CODES
ERROR
DETECTED
ERROR
DESCRIPTION
TROUBLESHOOTING
335-338
STORAGE_CONTAINER”X”_RESET_ERR
OR, where “X”=1..4
Slave “X” CAN SELECTION
reset procedure duration time-
out
Verify the cleanliness and positioning of the
photocells of the “X” CAN unit, then clean
or refix the sensor. Verify the integrity of
the motors and the connectors, and replace
the parts or the entire unit if any
mechanical wear or damage is found. If the
communication is present but a problem of
an electronic type remains, replace the
SCCB board.
339-340
PLUG_COVER”X”_RESET_ERROR, where
“X” = 1..2
Slave “X” CAPPING STATION
reset procedure duration time-
out
Verify the cleanliness and positioning of the
photocells of the “X” CAPPING unit, then
clean or refix the sensor. Verify the integrity
of the motors and the connectors, and
replace the parts or the entire unit if any
mechanical wear or damage is found. If the
communication is present but a problem of
an electronic type remains, replace the
SCCB board.
341
AUTOCAP_PACKING_ERROR
Autocap has NOT reached the
packaging position within the set
TIME-OUT
Verify the cleanliness of the mechanical
parts and sensors, and remove any
residues if necessary. Verify the integrity of
the motor and replace it if deterioration is
encountered. If any mechanical parts are
damaged or jammed, remove or change
the mechanical parts in question.
Verify the electrical connections and
change them if damaged. Check the
photocell sensors and reposition them or
change them if damaged.
342
AUTOCAP_HOMING_ERROR
Loss of steps: deviation upon
the detection of slave AUTOCAP
HOME position
Verify the cleanliness of the mechanical
parts and sensors, and remove any
residues if necessary. Verify the integrity of
the motor and replace it if deterioration is
encountered. If any mechanical parts are
damaged or jammed, remove or change
the mechanical parts in question.
Verify the electrical connections and
change them if damaged. Check the
photocell sensors and reposition them or
change them if damaged.
351-358
B”X”_DATA_SUPPLY_FAILED, where “X” =
1..8
Invalid table parameters
Check for consistency errors between the
tables and the circuit installed on the
machine. Verify the proper installation of
the calibration tables in the Machine menu.
359-382
C”X”_DATA_SUPPLY_FAILED, where “X” =
1..24
Invalid table parameters
Check for consistency errors between the
tables and the circuit installed on the
machine. Verify the proper installation of
the calibration tables in the Machine menu.