Alfa Network Color Tester, Техническое руководство

Страница: 35 / 45

Technical Manual
– Color Tester
EN TROUBLE SHOOTING
35
9. TROUBLE SHOOTING
ERROR
CODES
ERROR
DETECTED
ERROR
DESCRIPTION
TROUBLESHOOTING
1
TIMERMG_TEST_FAILED
Timer operation test failure
Test failure means that the program on the
MAB board has stopped working. Restart
the program
2
EEPROM_COLOR_CIRC_PARAM_CRC
_FAULT
Circuit parameter CRC fault
Check for the absence of parameters in the
case of MAB replacement. Load the
master/colorant circuit parameters onto the
new MAB board
3
EEPROM_CALIB_CURVES_PARAM_CRC
_FAULT
Calibration curve parameter
CRC fault
Check for the absence of parameters in the
case of MAB replacement. Load the
calibration parameters onto the new MAB
board
4
EEPROM_XY_OFFSET_PARAM_CRC
_FAULT
Failure of x and y coordinates,
Cartesian positions, offset CRC
Check for the absence of parameters in the
case of MAB replacement. Load x and y
offset parameters onto the new MAB board
5
EEPROM_SLAVES_EN_PARAM_CRC
_FAULT
Slave configuration CRC fault
Check for the absence of parameters in the
case of MAB replacement. Load the
SLAVE configurations onto the new MAB
board
10
USER_INTERRUPT
Machine operation Software
interruption
HALT has been pressed
11-18
TIMEOUT_COM_MAB_ACT “X”, where “X”
= 1..8
"X" BASE slave communication
time-out (detected on the MAB
side)
Check the SCCB power supply wiring and
replace it if damaged. Check the RS485
communication connector, and visually
check the board hardware. If damaged,
replace the ”X” BASE slave board
19-42
TIMEOUT_COM_MAB_ACT “X”, where “X”
= 1..24
"X" COLORANT slave
communication time-out
(detected on the MAB side)
Check the SCCB power supply wiring and
replace it if damaged. Check the RS485
communication connector, and visually
check the board hardware. If damaged,
replace the ”X” COLORANT Slave board
43
MOVE_X_AXIS_IDX
Slave X AXIS communication
time-out (detected on the MAB
side)
Check the SCCB power supply wiring and
replace it if damaged. Check the RS485
communication connector, and visually check
the board hardware. If damaged, replace the X
AXIS board
44
MOVE_Y_AXIS_IDX
Slave Y AXIS communication
time-out (detected on the MAB
side)
Check the SCCB power supply wiring and
replace it if damaged. Check the RS485
communication connector, and visually check
the board hardware. If damaged, replace the Y
AXIS board
45-48
STORAGE_CONTAINER ”X”_IDX where
“X”=1..4
"X" CAN slave communication
time-out (detected on the MAB
side)
Check the SCCB power supply wiring and
replace it if damaged. Check the RS485
communication connector, and visually
check the board hardware. If damaged,
replace the ”X” CAN Slave board