Alfa Network Color Tester, Техническое руководство

Страница: 22 / 45

Technical Manual
– Color Tester
22
PROGRAMMING THE ELECTRONIC BOARDS EN
4.2.6. SETTING ADDRESSES
For programming an SCCB actuator board, the address set via the dip-switches must be consistent with the Target
selected via the programming software (see previous paragraph).
Before programming a board, set the corresponding dip-switches accordingly.
Dip-switch addressing is a binary code.
The least significant bit is the leftmost one. A dip-switch set to ON co
rresponds to a bit value of ‘1’.
SCCB must have a fixed addressing, as follows:
GROUP OR CIRCUIT DIP-SWITCH
BASE or MASTER B1-B8 (or M1-M8): ADDRESS 1...8
…
COLORANTS C1-
C24: ADDRESS 9…32
…
X-AXIS: ADDRESS 33
Y-AXIS: ADDRESS 34
CAN SELECTOR 1-
4: ADDRESS 35…38
…
CAPPING 1-
2: ADDRESS 39…40
…
AUTOCAP: ADDRESS 41
CAN LIFTER: ADDRESS 42
HUMIDIFIER: ADDRESS 43
Each address must be unique in the machine.
After programming, board address can be changed but only into addresses belonging to the same group of circuits
(colorants, bases, etc.).
4.3. BOOTLOADER 2.0
Boot Loader 2.0 generation will include the possibility to remotely update the Firmware of ALFA machines, only by
means of ALFA Software, with no need of any USB cable and without physically switching the machine off and back
on.
If newer Firmware versions are found, a message will warn the operator, specify the name and type of the Firmware
versions available, and propose the update with a new Firmware version. The operator shall then select which
versions to install.