Alfa Network Color Tester, Техническое руководство

Страница: 39 / 45

Technical Manual
– Color Tester
EN TROUBLE SHOOTING
39
ERROR
CODES
ERROR
DETECTED
ERROR
DESCRIPTION
TROUBLESHOOTING
226-229
STORAGE_CONTAINER”X”_HOME_POS_
ERROR, where “X=1..4
Loss of steps: deviation upon
the detection of “X” CAN
SELECTION slave HOME
position
Verify the cleanliness of the mechanical
parts and sensors, and remove any
residues if necessary. Verify the integrity of
the motor and replace it if deterioration is
encountered. If any mechanical parts are
damaged or jammed, remove or change
the mechanical parts in question.
Verify the electrical connections and
change them if damaged. Check the
photocell sensors and reposition them or
change them if damaged.
230
AUTOCAP_HOME_POS_ERROR
Loss of steps: deviation upon
the detection of slave AUTOCAP
HOME position
Verify the cleanliness of the mechanical
parts and sensors, and remove any
residues if necessary. Verify the integrity of
the motor and replace it if deterioration is
encountered. If any mechanical parts are
damaged or jammed, remove or change
the mechanical parts in question.
Verify the electrical connections and
change them if damaged. Check the
photocell sensors and reposition them or
change them if damaged.
231
AUTOCAP_PACK_POS_ERROR
Cup Lift Homing procedure upon
RESET was NOT carried out
successfully
At least 1 of the transitions did not take
place: Covered-Uncovered, Uncovered-
Covered during lift Reset.
Check the operation of the photocell, the lift
motor and any obstacle that hinders the
movement
232
PLUG_COVER1_PHOTOC_ERROR
Error on the photocell controlling
Capping station 1 position
During Reset, or at the end of Dispensing
the Capping 1 correct positioning photocell
has not been engaged. Check for obstacles
and check correct photocell operation
233
PLUG_COVER2_PHOTOC_ERROR
Error on the photocell controlling
Capping station 2 position
During Reset, or at the end of Dispensing
the Capping 1 correct positioning photocell
has not been engaged. Check for obstacles
and check correct photocell operation
234
CLAMP_POSITION_ERROR
Can in filling position error
When the machine is in STANDBY the
microswitch detecting can presence in
filling area is engaged: check the actual
presence and remove if necessary.
235
CAN_LIFTER_STUCKED
Can badly positioned at the end
of lifting before dispensing Start
Before dispensing start, when the lift has
completed its movement, can presence is
detected. Check can correct positioning in
the lift, and the operation of the photocell
detecting the can
236
X_AXIS_NOT_AVAILABLE
X axis NOT enabled
Change machine configuration in the
EEPROM of MAB enabling X axis
237
Y_AXIS_NOT_AVAILABLE
Y axis NOT enabled
Change machine configuration in the
EEPROM of MAB enabling Y axis