Alfa Network 4PIZZE, Руководство пользователя

Страница: 11 / 27

18 19
FOR YOUR SAFETY:
- Do not exceed the limit temperature of 450°C (840°F).
- Do not leave the oven unattended when the fire gest going.
- Never run the oven full throttle for too long.
- Never disconnect the gas pipe or other fittings when the oven is in operation.
- Do not touch the external surfaces and the flue during use because they can get
too hot.
- In case of naked flames, contact Alfa technical support.
OTHER COMMANDS
- To extinguish the flame of the main burner and leave only the pilot light on, turn the
knob to the star.
- To switch off the main burner and the pilot light, turn the knob to the “0” position.
- If the flame does not light, release the knob and turn it back to the “0” position, wait
for about 3 minutes and repeat the procedure. If it takes several tries to ignite, keep
the knob pressed in the ignition position (Fig. 1) for a few minutes in order to drain the
gas inside the pipe.
WARNING: Before firing up the oven, follow the instructions.
- Check all gas connections before using the oven.
- Do not lean over the oven when lighting it.
- Keep your face and your body at least 50 cm away from the oven door. There must be no
door, when lighting the oven.
- The gas knob must be in the “0” position.
1. To ignite the pilot light, press and turn the knob
to the spark symbol.
2. Press the gas knob and the ignition button at
the same time to spark the pilot light.
N.B. The ignition of the pilot light might need
several attempts due to the air in the supply
line, so be patient.
3. Once the pilot light is on, release the ignition
button but KEEP PRESSING the burner knob
for about 15 seconds to allow the thermocouple
to heat up enough.
4. Release the gas knob and turn it counter-
clockwise to high flame setting to heat up the
oven.
IGNITION
FOR GAS-FIRED OVENS ONLY
continue next page >>
ELECTRONIC BUTTON
ONLY FOR GAS OVENS
The ignition button comes with AA battery included. To install it, follow this
procedure.
1. Unscrew the button head.
2. Put in the battery.
3. Screw the button head.
Carry out these operations when the oven is off.
Remove the battery during long periods of inactivity.
ATTENTION
Follow the specific instructions for each model,
in this manual from page 42 to page 49