Alfa Laval DuraCirc Range, Инструкция по эксплуатации

Страница: 55 / 69

3206-0071
12
O-ring seal fitting:
NOTE: Ensure all screws and nuts are
torqued to the values stated in Section 6.
1. Flushed seal only: Apply a small amount
of suitable lubrication to the new lip seal
(126) and press fit to the rear seal bore of
the rotorcase (2) until flush with end of
bore. Refit the rotorcase ensuring the
rotor case screws (11) are tightened
correctly.
2. If the static assembly was removed lightly
lubricate the static o-ring (123) and fit to
the static assembly (121). Align the mark
on the front face of the static assembly
with the lugs in the bore of the rotorcase
(2) and push back ensuring the static
assembly is kept square to the bore until
fully engaged.
3. Lightly lubricate the outer sleeve O-ring
(124) and inner sleeve O-ring (125) and fit
to the sleeve (120).
4. Align the slots in the sleeve with the pins
in the rotor (3) and push until fully seated.
5. Without lubricating, fit primary O-ring
(122) in to the static assembly ensuring it
is pushed firmly and evenly in to position.
6. Lightly lubricate the outside diameter of
the sleeve.
3206-0078
3206-0112
3206-0113
200002348-1-EN-GB 55
Maintenance 5 EN