3 Installation
Study the instructions carefully and pay special attention to the warnings!
Always check the Agitator before operation - see chapter 3.3 Pre-use check.
The Agitator is for permanent fastening.
Make sure that the motor correspond to the environment.
3.3
Pre-use check
Always make sure that the ATEX category stated on the Agitator name plate corresponds with the environment it is
installed in.
Never install the Agitator in environments which deviate from those given in chapter 2.3 Intended use and 6.1 Technical data.
Always ensure that all alignment specifications given in chapter 6.6 Shaft alignment are followed.
Always make sure that the motor corresponds to the environment.
Step 1
Go through chapter 2.4 Safety precautions.
Step 2
Check the fastenings.
Step 3
Check o-ring and impeller are correctly fitted.
Step 4
Check impellers CANNOT collide with tank vessel at any point
during a full rotation.
Clearance > S/15
and
Clearance > 20mm
4303-0144
Step 5
Seal
-
Ensure the sealing surfaces are not stuck together, by slowly
turning shaft by hand.
-
Ensure that the seal never runs dry.
21
