6 Technical data
All dimensions in mm unless otherwise stated.
6.1
Technical data
The Alfa Laval Agitator is available in various configurations and is configured to solve the specific application. Therefore specific
information like weight, size, critical oscillation speed and duties can be found in the supplied Alfa Laval quotation agreement.
Important installation information about weight and mounting angle can be found on the supplied Agitator name plate as
shown on the illustration.
4303-0020
6.2
Mounting angle for side mounted Agitator type ALS
To ensure optimal agitation the side mounted Agitator must be installed in the mounting
angle specified on the name plate, as described in the Alfa Laval quotation agreement
and as shown on the illustration.
4303-0009
The side mounted Agitator must also be installed in either an offset distance (E) from
the center of the tank or it must be installed an offset angle (E*) from the center of the
tank as shown on illustration section A-A
The distance (E) can be calculated as follows:
E = C x tan(5-7°), where C = tank radius
If the offset angle is chosen it must be as follows: E* = 5-7°
NOTE
In certain cases the offset angle E* is recommended to be larger - e.g. 10-12°.
- it will be communicated via the Alfa Laval quotation agreement.
43030008
31
