14/35
ALFA IN a.s. ©
www.alfain.eu
The button serves to exit any menu without saving any
changes.
P4
This button selects the torch trigger procedure.
10 TORCH TRIGGER MODES
P5
This button selects the welding mode.
P6
Data setting:
The encoder adjusts the main welding (and
synergy) parameter, shown on the following display:
P12
P7
This LED illuminates to show that the following welding
mode is selected: DOUBLE PULSED SYNERGIC MIG/MAG
P8
This LED illuminates to show that the following welding
mode is selected: PULSED SYNERGIC MIG/MAG
P9
This LED illuminates to show that the following welding
mode is selected: SYNERGIC MIG/MAG
P10
This LED illuminates to show that the following welding
mode is selected: MANUAL MIG/MAG
P11
Manual MIG/MAG mode: The button is not active.
Synergic MIG/MAG mode:
The button cycles through the
following LEDs in sequence, selecting only one: / /
P12
During illumination of the following LEDs: / /
The display shows the value of the selected parameter.
Welding:
The display shows the effective amperes value
during welding.
HOLD function (at welding end):
The display shows the
latest measured current value.
P13
When this LED illuminates the following parameter can be
set: WIRE FEED RATE
The value appears on the following display:
P12
.
P14
Short-Spray, pulsed and synergic MIG/MAG welding:
When this LED illuminates the following parameter can be
set: WELDING CURRENT
HOLD function (at welding end):
Illuminates to show a value in the following unit of
measurement: AMPERES
The value appears on the following display:
P12
P15
This LED illuminates to show an anomaly in the operating
conditions.
An alarm message appears on the following display:
P19
12 ALARMS MANAGEMENT
P16
When this LED illuminates the following parameter can be
set: WELDING THICKNESS
(Reference is made to "T" fillet welds on identical
thicknesses. The relative value is purely guideline).
The value appears on the following display:
P12
