Aleratec 280113, Руководство пользователя, Страница: 10 / 48

www.aleratec.com 4
Overview
Hardware Installation Procedure
1. Remove the DVD/CD RoboRacer LS Duplex Win/Mac from the box.
Plug the male end of the power cord into a 110VAC power source.
Plug the female end of the power cord into the back of the DVD/
CD RoboRacer LS Duplex Win/Mac and leave the power switch off,
(power on the device after the software has been installed). Place the
RoboRacer LS Duplex Win/Mac on a level surface.
2. Plug the USB cable into the PC and the DVD/CD RoboRacer LS
Duplex Win/Mac.
3. Remove the colored plastic bases from the three output bins. To do this
you first must break the two black pins on each base, pushing them in
the direction the arrow on the base points. Save the bases along with
the other packaging foam in the product box in case your unit needs to
be transported.
4. Slide bin holders into the two slots on the left side of the RoboRacer LS
Duplex Win/Mac case and place a disc output bin into each bin holder.
There are two types of output bins included (Two 50-disc capacity, one
100-disc capacity). Make sure to keep the output bins that come with
the 280111. Although a normal disc media spindle cover may work, the
RoboRacer LS Duplex Win/Mac has been designed to use the provided
Disc Output Bins included. When installing, make sure that the flanges
on the bin are touching the lip of the bin holder. If the bin is not pushed
down as far as it can go, the edge of the bin could interfere with the
disc output. To use the 100 disc bin in the lower slot, the DVD/CD
RoboRacer LS Duplex Win/Mac should be placed at the edge of a desk
or table. Make sure that the bin does not touch the edge of the desk or
table surface. Also, make sure to not place the 280111 over the edge,
the weight of the discs may result in a fall.
5. Take the clear plastic disc guide rods and place them into the 4 holes
in the top of the unit. To load the discs into the input bin, take one disc
and place it horizontally level in the input bin. Now you can load the
rest of the discs. All of the discs need to be level with the sides of the
stack straight.