62
Key
Description
TEMP+
•
While the console using battery supply only, press this
button to switch display between Outdoor Temperature,
Wind Chill, Dew Point, Heat Index. While using DC
supply, press the button to switch display between
Outdoor Temperature, Chill, Dew Point, Heat Index, 8
channel temperature and humidity (optional), Circle Mode.
WIND -
•
Press to switch between average wind speed and, wind
gust.
•
Press and hold for two seconds to switch the wind
direction to display in degrees or in letters.
RAIN/PRE
•
Press and hold for two seconds switch between Rain and
Pressure.
•
While in Rain mode, press to switch between Rain Rate,
Rain Events, Hourly Rain, Daily Rain, Weekly Rain,
Monthly Rain and Yearly Rain
•
While in Pressure mode, press to switch between Relative
pressure and Absolute pressure
LIGHT
•
Press to adjust the LCD backlight brightness (high,
medium and off); only available when powered by USB
connection
•
Press to exit the SET mode at any time.
TEMP+
(and) RAIN
PRE
•
Press this two buttons at the same time for 4 seconds to
activate BLE function for Wi-Fi configuration (refer to
section 8. 1. 2)
Table 7: Key function
5.3 Setting mode
Note:
DST, Time Zone setting can only be programmed via WS View APP.
You will need to set time zone info properly if you have the console connected
to internet and these setting need to be adjusted for your setup, otherwise
console will be synchronized to default setting if you don’t setup these
parameters on the APP properly.
Press and hold the
MODE
button for two seconds to enter the Set Mode. To
proceed to the next setting, press (do not hold) the
MODE
button.
To exit the SET mode at any time, press the
LIGHT
button.
Table 8 summarizes the set mode sequence and commands.
Factory Default Reset:
[MODE] + [LIGHT] for 5s
