Alderon Industries VersAlarm I/O, Руководство пользователя

Страница: 11 / 20

Alderon Industries™ - Leading Edge Control Products | 11
VersAlarm™ I/O - USER GUIDE
Septic Tank Monitoring
The diagram below shows the typical setup for septic tank monitoring. The VersAlarm™ I/O is shown in two locations to demon-
strate the most typical options for septic tank monitoring. The alarm float switch is connected to the sensor input for high water
indication. If water level is not high enough to activate the alarm float switch, then the top cover of the enclosure will be green.
If the alarm float switch is activated, then the top cover of the enclosure will flash red and the buzzer will annunciate. The alarm
condition will stay on until the alarm float switch is deactivated. If the silence pushbutton is pressed during an alarm condition,
then the top cover of the enclosure will turn solid red and the buzzer will silence. The silence condition will reset when the alarm
float switch deactivates. If the alarm is in silence mode for longer than 24 hours, the alarm will reactivate.
1) Indoor Application - The first option shows the VersAlarm™ I/O mounted in the utility room. The alarm float switch will
need splicing for the additional wire length. A second common indoor installation method is mounting the alarm in the
garage (not shown).
2) Outdoor Application - The second option is to mount the VersAlarm™ I/O to a post in the ground next to the septic tank.
This option would require a shorter alarm float switch cable length and running the power mains out to the alarm.
13:27
Cycle: WASH
HEAT TIME
START
Septic
to
Drain Field
VersAlarm™ I/O
VersAlarm™ I/O
Alarm
Float
Pump
Switch
2
1