5
2480 Remote Intensifier Tooling Alcoa Fastening Systems
This instruction manual must be read with particular
attention to the following safety guide
lines, by
any person servicing or operating this tool.
1.
Safety Glossary
WARNINGS - Must be understood
to avoid severe personal injury.
CAUTIONS
-
show conditions that will
damage equipment and or structure.
Notes
- are reminders of required
procedures.
Bold, Italic type and underlining -
emphasizes a specific instruction.
2.
Huck equipment must be maintained in a safe
working condition at all times and inspected on a
regular basis for damage or wear. Any repair
should be done by a qualified repairman trained
on Huck procedures.
3.
Repairman and Operator must read manual prior
to using equipment and understand any Warning
and Caution stickers/labels supplied with
equipment before connecting equipment to any
primary power supply. As applicable, each of the
sections in this manual have specific safety and
other information.
4.
See MSDS Specifications before servicing the
tool. MSDS Specifications are available from
you Huck representative or on-line at
www.huck.com. Click on Installation Systems
Division.
5.
When repairing or operating Huck installation
equipment, always wear approved eye
protection. Where applicable, refer to ANSI
Z87.1 - 1989
6.
Disconnect primary power source before doing
maintenance on Huck equipment.
7.
If any equipment shows signs of damage, wear,
or leakage, do not connect it to the primary
power supply.
8.
Make sure proper power source is used at all
times.
9.
Never remove any safety guards or pintail
deflector.
10.
Never install a fastener in free air. Personal
injury from fastener ejecting may occur.
11.
When using an offset nose always clear spent
pintail out of nose assembly before installing the
next fastener.
12.
If there is a pinch point between trigger and
work piece use remote trigger. (Remote
triggers are available for all tooling).
13.
Do not abuse tool by dropping or using it as a
hammer. Never use hydraulic or air lines as a
handle. Reasonable care of installation tools by
operators is an important factor in maintaining
tool efficiency, eliminating downtime, and in
preventing an accident which may cause severe
personal injury.
14.
Never place hands between nose assembly and
work piece.
15.
Tools with ejector rods should never be cycled
with out nose assembly installed.
16.
When two piece lock bolts are being used
always make sure the collar orientation is
correct. See fastener data sheet of correct
positioning.
!
Product complies with requirements
set forth by the relevant European
directives.
Read manual prior to using
equipment.
Eye protection required while
using this equipment.
Hearing protection required while
using this equipment.
S
S
AFETY
AFETY