Configuring OSPFv3
OSPFv3 Quick Steps
OmniSwitch AOS Release 7 Advanced Routing Configuration Guide
March 2011
page 2-5
9
You can now display the router OSPFv3 settings by using the
show ipv6 ospf
command. The output
generated is similar to the following:
10
You can display OSPFv3 area settings using the
show ipv6 ospf area
command. For example:
-> show ipv6 ospf
Status = Enabled,
Router ID = 5.5.5.5,
# Areas = 2,
# Interfaces = 4,
Area Border Router = Yes,
AS Border Router = No,
External Route Tag = 0,
SPF Hold (seconds) = 10,
SPF Delay (seconds) = 5,
MTU checking
= Enabled,
# SPF calculations performed
= 3,
Last SPF run (seconds ago)
= N/A,
# of routes = 0
# of AS external LSAs = 0,
# of neighbors that are in:
Full state
= 3,
Loading state
= 0,
Exchange state
= 0,
Exstart state
= 0,
2way state
= 0,
Init state
= 0,
Attempt state
= 0,
Down state
= 0
Router ID
As set in Step 5
-> show ipv6 ospf area
Stub Number of
Area ID Type Metric Interfaces
---------------+-------+------+------------------------
0.0.0.0 Normal NA 2
0.0.0.1
Normal NA 2
Area ID
As set in Step 6