Configuring OSPF
Verifying OSPF Configuration
OmniSwitch AOS Release 7 Advanced Routing Configuration Guide
March 2011
page 1-37
Verifying OSPF Configuration
To display information about areas, interfaces, virtual links, redistribution, or OPSF in general, use the
show
commands listed in the following table:
For more information about the resulting displays form these commands, see the “OSPF Commands”
chapter in the
OmniSwitch CLI Reference Guide
.
Examples of the
show ip ospf
,
show ip ospf area
, and
show ip ospf interface
command outputs are given
in the section
“OSPF Quick Steps” on page 1-4
.
show ip ospf
Displays OSPF status and general configuration parameters.
show ip ospf border-routers
Displays information regarding all or specified border routers.
show ip ospf ext-lsdb
Displays external Link State Advertisements from the areas to which the
router is attached.
show ip ospf host
Displays information on directly attached hosts.
show ip ospf lsdb
Displays LSAs in the Link State Database associated with each area.
show ip ospf neighbor
Displays information on OSPF non-virtual neighbor routers.
show ip redist
Displays the route map redistribution configuration.
show ip ospf routes
Displays OSPF routes known to the router.
show ip ospf virtual-link
Displays virtual link information.
show ip ospf virtual-neighbor
Displays OSPF virtual neighbors.
show ip ospf area
Displays either all OSPF areas, or a specified OSPF area.
show ip ospf area range
Displays all or specified configured area address range summaries for
the given area.
show ip ospf area stub
Displays stub area status.
show ip ospf interface
Displays OSPF interface information.
show ip ospf restart
Displays the OSPF graceful restart related configuration and status.
