....................................................................................................................................................................................................................................
4-12
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
Installation
Pre-installation cabling
....................................................................................................................................................................................................................................
Install SFP transceiver module
WARNING
Laser hazard
Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous laser radiation exposure.
Do not view directly into the laser beam with optical instruments such as a fiber
microscope because viewing of laser emission in excess of Class 1 limits significantly
increases the risk of eye damage.
Never look into the end of an exposed fiber or an open connector as long as the optical
source is switched on.
Ensure that the optical source is switched off before disconnecting optical fiber
connectors.
NOTICE
ESD hazard
Semiconductor devices can be damaged by electrostatic discharges (ESD)
Always observe the general ESD instructions for handling modules containing
semiconductor components.
Before the Ethernet cable can be connected to the 9764 CMCO, the SFP port(s) must be
equipped with the appropriate SFP transceiver (either 1000Base-X GigE optical
transceiver or 10/100/1000Base-T electrical transceiver), according to the network
specifications.
To install an SFP transceiver module into the 9764 CMCO SFP port:
...................................................................................................................................................................................................
1
Firstly, carry out the following to attach the ESD wrist strap:
1.
Attach the ESD strap over your wrist so that is in contact with your bare skin.
2.
Momentarily touch the ESD clip onto a bare (unpainted) metal spot so that any built
up static charge is dissipated.
3.
Attach the ESD clip to the MCO ground lug screw (the ground lug screw can be
unscrewed slightly for easier ESD clip attachment).
