Albion 860-48-59-6561, Руководство оператора

Страница: 4 / 12

Page 4
Maintaining Tool
Keep your tool, battery pack and charger in good repair by adopting a regular
maintenance program. After six months to one year, depending on use,
return the tool, battery pack and charger to ALBION ENGINEERING for:
• Lubrication
• Brush inspection and replacement
• Mechanical inspection and cleaning (gears, spindles,
bearings, housing, etc.)
• Electrical inspection (battery pack, charger, motor)
• Testing to assure proper mechanical and electrical operation
If the tool does not start or operate at full power with a fully charged battery
pack, clean the contacts on the battery pack. If the tool still does not work
properly, contact ALBION ENGINEERING Co. for all repairs.
Maintaining Battery Pack
ALBION 12 and 14.4 Volt Series 1000 battery packs will operate for many
years and/or hundreds of cycles when they are maintained and used
according to these instructions.
A battery pack that is stored for six months without being used will discharge
itself. Batteries discharge at a rate of about 1% per day. Charge the battery
every six months even if it is unused to maximize battery life. Do not tape
the trigger in the “ON” position and leave the tool unattended as this may
discharge the battery to a point where it will no longer be able to recharge.
Use an ALBION Volt Series 1000 battery pack only until it no longer performs
with the power and torque needed for your application.
Store your battery pack in a cool, dry place. Do not store it where the
temperature may exceed 120°F (50°C) such as in a vehicle or metal building
during the summer. High temperatures will overheat the battery pack,
reducing battery life. If it is stored for several months, the battery pack will
gradually lose its charge. One to three cycles of charging and discharging
through normal use will restore the capacity of the battery pack. During the
life of the battery pack, the operating time between charges becomes
shorter. If the operating time becomes extremely short after a proper charge,
the usable life of the battery pack has been reached and it should be
replaced.
MAINTENANCE
Cleaning
Clean dust and debris from charger and tool vents. Keep tool handles clean,
dry and free of oil or grease. Use only mild soap and a damp cloth to clean
the tool, battery pack and charger since certain cleaning agents and
solvents are harmful to plastics and other insulated parts. Some of these
include gasoline, turpentine, lacquer thinner, paint thinner, chlorinated
cleaning solvents, ammonia and household detergents containing ammonia.
Never use flammable or combustible solvents around tools.
WARRANTY
To reduce the risk of personal injury and
damage, never immerse your tool, bat-
tery pack or charger in liquid or allow a
liquid to flow inside them.
WARNING!
To reduce the risk of personal injury,
always unplug the charger and remove
the battery pack from the charger or tool
before performing any maintenance.
Never disassemble the tool, battery pack
or charger. Contact ALBION ENGINEER-
ING Co. for ALL repairs.
WARNING!
Disposing of Nickel-Cadmium Battery Packs
Nickel-Cadmium battery packs are recyclable. Under various state and local
laws, it may be illegal to dispose of this battery into the municipal waste
stream. Dispose of your battery pack according to federal, state and local
regulations.
Disposing of Nickel-Metal Hydride Battery Packs
Nickel-Metal Hydride battery packs are recyclable. Always dispose of your
battery pack according to federal, state and local regulations.
Repairs
For repairs, contact ALBION ENGINEERING Co. at (856) 235-6688 or
service@albioneng.com.
Battery Pack Warranty
Battery packs for cordless tools are warranted for one year from the date
of purchase.
To reduce the risk of explosion, never
burn a battery pack even if it is damaged,
dead or completely discharged.
WARNING!
Every ALBION product is warranted to be free from defects in material and
workmanship. ALBION will repair or replace any product which examination
proves to be defective in material or workmanship.
Limitations: This warranty does not cover: 1) repairs made or attempted
by other than ALBION ENGINEERING or ALBION ENGINEERING Autho-
rized Service Station personnel; 2) normal wear and tear; 3) abuse; 4)
misuse; 5) improper maintenance; 6) continued use after partial failure; 7)
tools that have been modified; or product used with an improper accessory.
Battery Packs are warranted for one (1) year from the date of purchase.
Should a problem develop, return the complete product to any
ALBION
ENGINEERING Factory Service Center or ALBION ENGINEERING Au-
thorized Service Station, freight prepaid and insured. If inspection shows
the problem is caused by a defect in material or workmanship, all repairs
or a replacement will be made at no charge and the product will be returned,
transportation prepaid. No other warranty, written or verbal, is authorized.
THE REPAIR AND REPLACEMENT REMEDIES DESCRIBED HEREIN ARE
EXCLUSIVE. IN NO EVENT SHALL ALBION ENGINEERING BE LIABLE FOR
ANY INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES, INCLUDING
LOSS OF PROFITS.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR
IMPLIED WHETHER FOR MERCHANTABILITY OR FITNESS FOR PARTICULAR
USE OR PURPOSE.
This warranty gives you specific legal rights. You may also have
other rights that vary from state to state. In those states that do not
allow the exclusion of implied warranties or limitations of inciden-
tal or consequential damages, the above limitations or exclusions
may not apply to you.