8
M
ANUAL
M
ODE
- when a note or coin is inserted (or when the value of one token is reached),
the button(s) will lit up green . Press the button corresponding to the change (token) desired.
If the machine is set to Change, it will be possible to choose the desired number of
tokens.
If the machine is set to Tokens or to Change, and the Bonus has been set, introduce
money until the searched amount is reached, then press the OK button.
WARNING: If there are not enough coins in the hopper to fulfil the whole exchange request, the remaining
credit shall be displayed and retained in memory. Switch off the machine, fill the hoppers, and switch on
again: the remaining credit shall be paid out.
An option is to set the Menu (see section 7.3.14) so as to cancel the remaining credit - and at the
same time record it in the Accounts menu - by switching the machine off and on again.
7.
System configuration
7.1
Default configuration
The SPIKE unit is preset by default as follows (unless requested for different setup):
Control Board Parametres
Pay-out mode
= AUTOMATIC
Bonus
= DISABLED
Level sensors
= DISABLED
Hopper S11 Parameters
Hopper nr. 1 (*) = € 2.00 = ENABLED
Hopper nr. 2 (*) = € 2.00 = ENABLED
Hopper AH4 discriminator [ccTalk]
Preset by default to 0,50 – 1,00 – 2,00 €
BILLYONE Validator [ccTalk] Parameters
€ 5.00 - …. - € 100.00 = ENABLED
AL66 S [ccTalk]coin acceptor Parameters
€ 0.05 - € 0.10 - € 0.20 = DISABLED
€ 0.50 - € 1.00 - € 2.00 = ENABLED
Restore default configuration
If any variation is made, it will be possible to restore the default configuration as follows:
enter the initial menu, scroll by UP and DOWN keys and choose
RESTORE DEFAULT CONFIGURATION
then press OK; the message
DEFAULT CONFIG
.
RESTORED
will be displayed.
NOTICE: the
RESTORE DEFAULT CONFIGURATION
command resets the default PIN code (0000) .
