13
Dispense mode
MANUAL
Dispense mode
AUTOMATIC
7.3.5.2 C
OIN SELECTOR SETUP
The board automatically detects the presence of the coin selector during initial check. Among the
accepted coins (0.05-to-2 €), the following ones get enabled by default: 0.50 € - 1.00 € - 2.00 €.
To modify this condition, press OK to get to the first option (ex. 2 €) and highlight it, then press UP
or DOWN to reverse its state
. Press OK to shift to the next option (ex. 1 €).
7.3.5.2
D
ISPENSING
M
ODE SETUP
Allows to choose to dispense C
OINS
or T
OKENS
or T
OKENS
+C
HANGE
, and if
DISPENSING MODE
must
be
AUTOMATIC
or
MANUAL
.
Also permits to control the level of the coins in the hopper(s) by optic sensors.
(*) Use keys Down and Up to
modify values
(*)
7.3.5.2 A PAY-OUT TABLE:
in
the versions provided with Pay-out Table, if and only if set up for
dispensing Tokens, the Automatic Mode allows to enable the Table or to disable it. If choosing to
enable it (OK button), the setting steps will be started. In the example below, tokens in hopper are set to
1€), and User will be allowed to buy only by amounts of 1, 2, 5, 10€, with bonus at 5 and 10 €.
Nine (9) value levels are available.
The Pay-out Table deploys its potentials in machines with 2+ hoppers.
WARNING! If the machine must be re-configured from token (or return change) to coin, always reset
to
DEFAULT CONFIGURATION
and cancel
ACCOUNTS
. Else, bonus logs will produce Accounts inconsistency.
Set up
COINS
Set up
Coin acceptor
2,00
1,00
< 0,50 >
OK
NO
OK
OK
OK
< 1,00 >
0,50
2,00
OK
< 2,00 > 1,00
0,50
NO
OK
OK
0,50
OK
OK
OK
< 2,00 > 1,00
Level sensors
enabled
Level sensors
disabled
Set up Hopper 1:
1,00 €
Set up
TOKENS
SET UP
DISPENSING MODE
< LEV 1 HP1>
1,00€ 0
Payout Settings
ENABLED
NOTICE: monitoring of level sensors is disabled by default. This means that the board does not know when the
hopper is empty, so it will send the pay-out command even if there are no coins available. When the hopper runs
out of coins during dispensing or at the end of payment, no warning will be displayed. If the empty state is
detected when powering the unit, this one shall not accept any money.
If instead the monitoring has been enabled, and there are not enough coins in the hopper, the display will warn
that the hopper is empty. There will usually remain 20 coins approximately, so as to complete the change
payout.
< LEV 2 HP1>
1,00€ 1
< LEV 4 HP1>
10,00€ 13
<LEV 2> HP1
1,00€ 1
< LEV 2> HP1
2,00€ 2
LEV 2 < HP1>
2,00€ 2
< LEV 3 HP1>
2,00€ 2
<LEV 3> HP1
2,00€ 2
<LEV 3> HP1
5,00€ 5
LEV 3 < HP1>
5,00€ 5
LEV 3 < HP1>
5,00€ 6
Payout Settings
(SEE ‘PAYOUT TABLE
NOTE’ BELOW)
Enable / Disable
POS
Enable
Dis.
