Alber viamobil eco, Руководство пользователя

Страница: 21 / 37

8
5. Transport
5. Dismantling viamobil into Components
Your viamobil can be dismantled into individual components for transport purposes.
Go ahead as follows to carry out this procedure:
Remove the rechargeable battery pack (see chapter 3.2).
Loosen and remove the hand wheel [6].
(Do not lose the hand wheel during transport!)
Remove the hand grips from the drive unit, as shown in the figure.
If necessary, the hand grips can be dismantled into further individual components as
follows:
Mark the location [A] of the handle bar [8] to the headset [11] with a pen in
order to be able to set the same position during reassembly at a later date.
Release the clamping screw [10] located in the clamping yoke [9] with a hexagon
socket screw key (key width 6mm) and remove.
Move the clamping yoke [9] upwards.
Remove the handle bar [8].
Screw the clamping screw [10] back into the claming yoke [9] for safe storage.
•
•
•
•
•
•
•
•
66
AA
10 9 10 9
5.2 Assembling viamobil Handle Bar
Release and remove the clamping screw [10] from the clamping yoke [9].
Open the clamping yoke [9] with a hexagon socket screw key (key width 6mm) and
insert the handle bar [8] into the receiver on the headset [11] to correspond with
the marking you previously made (see chapter 5).
Close the clamping yoke [9] and screw together using the clamping screw [10]
with 8 Nm torque. For this you should once again use the hexagon socket screw
key with a 6 mm key width.
Slide the hand grips into the drive unit.
Screw the hand grips and the drive unit together using the hand wheel [6].
Insert the rechargeable battery pack into the drive unit (see chapter 3.1).
Your viamobil is now ready for operation again.
Please pay attention to the instructions in chapter 6 provided that a
readjustment of the handle bar [8] seems necessary.
•
•
•
•
•
•
8
11
8
11
10 9
8
10 9
8
66
GA-V14-USA.indd 18 18.09.2006 11:51:35