Alber viamobil eco, Руководство пользователя

Страница: 10 / 37

8 7
2.2 Activating Roll Operation
Your viamobil can be manually pushed without requiring the support of the motor
when in so-called „roll operation“. This feature is solely intended for inserting and
removing the viamobil underneath the wheelchair.
Turn the operating button [12] into „Roll“ position. The handle bar [8] has to
be in the resting position (middle position) - should therefore neither be pulled
upwards, nor pressed downwards! Non-observance of these instructions results in a
fault indication (6 x blinking light, see also chapter 7.2) in the LED status display
[13]
If the operating button [12] is in „Roll“ position, the handle bar [8] with its
handle bar handles [7] has to be quickly pressed as far down as possible until it
stops and then immediately released again. A fault indication (6 x blinking light,
see also chapter 7.2) is shown in the LED status display [13] if the handle bar is
pressed down for too long. Switch off the viamobil and then restart and repeat the
procedure.
Wait approx. 2 seconds until the brakes unlock. You will be able to hear a clicking
sound.
The LED status display [13] lights up permanently, the viamobil can be pushed
(without the support of the motor).
The electronics on the viamobil have determined a fault if the LED
status display blinks and is not permanently lit up. Switch off viamo-
bil and then restart.
Please observe instructions regarding this matter in chapter 7.2.
Never activate roll operation when driving on uphill or downhill slo-
pes. The wheelchair could unintentionally start moving due to care-
lessness!
For safety reasons the brakes are temporarily activated if pushing or
rolling is deemed as too fast.
•
•
•
•
12
8
12
8
13 12 13 12
7
7
8
7
7
8
GA-V14-USA.indd 7 18.09.2006 11:51:22