Alber e-fix eco, Инструкция по эксплуатации

Страница: 38 / 53

8 33
Display Error Remedy
M16 to
M19 Drive overload error
•
The load is too high for the drive. Prevent overloading.
M20 to
M51 Check electronics, drive failure
•
Switch the system off and then on again.
•
Swap the two wheels from the left to the right and from
the right to the left-hand side.
M52 Right drive disengaged
•
Engage the right wheel.
M53 Left drive disengaged
•
Engage the left wheel.
M54 Left and right drive disengaged
•
Engage both wheels.
M55,
M56 High drive temperature
•
Reduce your speed.
•
Let the drive cool down.
S10,
S11 Unable to communicate with the wheel
•
Switch the system off and then on again.
•
Swap the two wheels from the left to the right and from
the right to the left-hand side.
•
If the error changes from S10 to S11: Swap the wheels
again.
S12 Unable to communicate with the battery pack
•
Switch the system off, take the control unit plug out
of the battery pack and take the battery pack out of the
interface.
•
Then insert the battery pack back into the interface and
connect the control unit.
S13 No system communication
•
Check all plug connections.
S15 Communication was interrupted during travel
•
Check all plug connections.
•
Switch the system off and then on again.
S17 External communication error
•
Contact your specialist dealer
If an error code appears in the display that is not listed in the table, switch the e-fix off and on again. If an
error is not resolved by doing this, please contact your specialist dealer. Depending on the type of error, the
affected components may need to be sent to Alber for repair.
i