ALAVs Transitional Species Blubber Bot, Руководство пользователя

Страница: 19 / 23

17
13
.
(A) Flip the assembly over. Repeat the process for the second motor, attaching it to the second carriage piece. (B) Place the assembly with the
back sides of the motors (side with the leads) facing you. This will be refereed to as the back side of the carriage system.
14
.
Each motor has two leads: one with a
white dot and one without. Grab the wire ex-
tending from the lead WITHOUT the white dot
on the left motor.
15
.
(A) Place the wire in the through-hole
marked “LM” (left motor). (B) Take the other
wire (white dot) and place it in the through-hole
to the left of the one marked “LM”. (C) Solder
wires in place from the backside of the PCB.
16
.
(A) Grab the wire from the right motor extending from the lead WITHOUT the white dot. (B) Place the wire in the through-hole from the back side
for the PCB marked “RM” (right motor). (C) Take the other wire (white dot) and place it in the through-hole to the left of the one marked “RM”. (D) Sol-
der wires in place from the front of the PCB. (E) Add propellers (part No. 10) to the motor shafts.
NOTE: THE WIRES FROM LEFT MOTOR WILL BE INSERTED IN THE FRONT SIDE OF THE PCB WHILE THE WIRES FROM THE RIGHT MOTOR WILL BE INSERTED FROM THE BACK.
NOTE: IT IS IMPORTANT THAT YOU
DON’T REVERSE THESE WIRES. IF YOU
REVERSE THE WIRES, THE BLUBBER
BOT WILL RUN FROM LIGHT RATHER
THAN SEEK IT (UNLESS YOU PREFER
THIS BEHAVIOR).