A Top Safety and Protection Solution Worldwide!
Page
２０
of 32 Ver 1.0
the siren will stop and you can listen in on the alarm area by phone.
Press the button “
” on the remote control, or press Disarm button on the
Keyboard then input the password, the Control Unit disarms immediately.
The
ICON will be off. Under this status, any sensor triggered, the control
unit will not alarm. Except if the sensor type is the 24-Hour Zones or
Watchdog zone or SOS zone.
Press the button “
” on the remote control or Press the Arm button on the
keyboard then select Stay, the Control Unit enters Stay(Partial Armed)
status, the
ICON will be on. In this status, the sensors had been set as
Stay Type triggered will alarm. The sensors which had been set as normal
Type triggered, will not alarm. Please see the menu of the
Edit RF Zone
.
Press Emergency button (SOS)
“
!
” on the
remote control
or the control unit
or Press any
Emergency button
. The Control Unit will enter emergency
alarm. The siren will not sound, but will alert the pre-set phone number
immediately.
7.2 SMS Commands for Arm or Disarm or Inquiry system status or
switch on/off independent output relay.
The User can Arm/Disarm/Inquriysystem status/Switch on or off the
independent output relay by sending SMS to the Control unit. The SMS
Commands are below:
Notice:
The system will carry out the commands immediately (with no delay) after the
Control Unit receive this SMS command.
7.2.1 Armed
7.2.2
Disarm
Example
1234AA
When the Password is 1234
xxxxAA
“xxxx” stands for the password
(1-4 digits).
Return SMS
All Armed Mode activated.
