2. Enter your Program Code into the keypad; the top three lights will flash and sounder will
pulse. Program up to 5 codes as follows:
a. Press Key [B].
b. Enter the user number (1-S). (Enter "5" for the Service Code.)
c. Enter a four-digit code number (digits 1-9; there is no zero).
Examples:
Press [B] + [1] + four digits = User 1 ‘s Code
[B] + [5] + four digits = User 5’s Code (or Service Code)
You do not have to assign all five codes. Use as many as you need and change them as often as
you
feel necessary.
To erase any code(s), repeat steps 1, 2a, and 2b. For example, to erase User 3, enter [B] + [3].
3. To end the programming mode, press Key [B]
twice.
SETTING
THE
ALARM
(ARMING) WHEN LEAVING
Checking
AC
Power
If the top three lights on the keypad are blinking slowly, you have lost ac power. Check if there
has been a general power outage, or if the control-panel power transformer is disconnected. If
you must operate without ac power, hold down Key [9] until a beep sounds to stop the lights
from blinking, then test your system by holding down Key [1]. If the alarm doesn’t sound, or is
weak, replace battery. Always test your system weekly.
Arming Before You Leave
Check the green READY light on the keypad. If it is on, enter your code. The red ARMED light
will come on and the green light will go off. If your system was programmed for an automatic
audible test on arming, the alarm will sound briefly shortly after arming.
Leave immediately through the exit/entry door before your exit delay time runs out. If you wait
too long, the keypad sounder will warn that the entry delay has started. To avoid causing an
alarm, quickly return to the keypad and enter your code to reset the control panel. You may then
arm the system again.
Arming With A Zone In Trouble
A flashing green READY light indicates that at least one non-24- Hour Zone is in trouble, that
is, the zone is in an “open” or “shorted” condition. If a Day Zone is open, the zone will also
display numerically and the sounder will be pulsing. Any zone (1 through 8) in a troubled
condition can be displayed numerically by holding down Key [3] until the sounder beeps. Try to
fix the zone by closing windows or doors that may be open. If a Day Zone is in trouble, reset the
Day-Zone indication by holding down Key [9] until the sounder beeps. (Reset the Day Zone by
correcting the condition, then arming and disarming.)If no zones are in trouble, the green light
will come on, indicating that the system is ready to be armed.
8
