PROTECTING YOURSELF WHILE ON THE PREMISES
Arming With Zones Bypassed
Your alarm specialist may have programmed one or more zones for Selective Bypass, that is,
removable from the system. Since a bypassed zone cannot cause an alarm, you may wish to use
this feature to turn off the interior areas while arming, and keep your perimeter zones (windows,
doors, etc.) active.
To arm, check the green light to be sure that no zone is in trouble. Press the bypass button (Key
[B]), and then the number of the zone (1 through 8) you wish to bypass. To verify which zones
have been bypassed, hold down Key [2] until all zones have been displayed.
Bypassing Interior Zones
Your alarm specialist may have also selected all interior zones to be Group Bypass Zones.
Bypass these zones all at the same time by simply pressing Key [B]
twice.
The yellow BYPASS
light will come on whenever you bypass one or more zones. Enter your code to arm remaining
zones; the green light will go off and the red ARMED light will come on. The yellow light will
go off the next time you disarm, indicating that the bypassed zones are no longer bypassed. (The
BYPASS light does not come on when zones are auto-bypassed (unless programmed otherwise
by your alarm specialist.)
NOTE: The Chime Mode may have been programmed to be enabled when group bypassing
interior zones so that perimeter Chime Zones will automatically sound at the keypad when
activated. Similarly, the Watch Mode (see
GLOSSARY)
may be enabled by group bypassing.
Arming With Instant Protection
Holding down Key [4] (until beep sounds) will cancel the entry delay on the exit/entry zones
when arming. The red ARMED light will flash
rapidly to indicate this condition. If someone
enters through an Exit/Entry Zone, an alarm will
sound immediately.
Panic Zone
To activate the Panic Zone, press Keys [*] and
[#] at the same time. The Panic Zone can be
programmed to send a silent alarm to a central
station, activate an audible alarm, or both.
10
