HOLD-DOWN FUNCTIONS
NOTE:
To perform designated “Hold-Down” Functions, Keys
[1]
- [9] and [B ] must be held
down for 2 seconds (until sounder beeps).
Key [I] : TEST
Momentarily sounds the burglar alarm. If no alarm is heard, or if it is weak, the battery may
need replacing. Make this test weekly. (To perform this function, hold down Key
[1]
until
sounder beeps.)
Key [2]: DISPLAY BYPASS
Numerically displays zones (1 through 8) that have been bypassed using Key [B]. To perform
this function, hold down Key [2] until sounder beeps, and continue to hold it down until all
zones have been displayed.
Key [3]: DISPLAY ZONES OPEN
Numerically displays zones (1 through 8) that are in “trouble”. To perform this function, hold
down Key [3] until sounder beeps, and continue to hold it down until all zones have been
displayed.
Key [4]: INSTANT PROTECTION
Cancels entry delay period when arming.
perform this function, hold down Key [4]
Key [5]: Chime
The delay is restored after you disarm the system. To
until sounder beeps.
This will enable a feature that sounds a “chime” (beep) at the keypad each time a programmed
zone is opened. (This feature may have been programmed to display the zone number as well
until the zone is closed.) The Chime Mode functions when the alarm system is disarmed (off),
but it will
always
operate on a Never-Armed Zone (see GLOSSARY). To disable the chime
feature, hold down Key [5] again (until sounder beeps). (Also see
Bypassing Interior Zones
on
page 10.)
Key [6]: COMMUNICATOR CONFIDENCE TEST
(Applicable only to systems programmed to report to a central station.)
Pressing the key tests your phone lines (the sounder will start to pulse). If the line is good, the
pulsing will stop: if not, a steady tone will sound. (To perform this function, hold down Key [6]
until sounder beeps.) Reset the sounder using Key [9].
Key [7]: FAULT FIND
For installer’s use only. (Arming the panel will cancel the Fault-Find Mode.)
Key [8]: PROGRAM
Allows you to enter the Program Mode. In this mode, you can program up to 5 personalized
User Codes, including a Service Code (optional). Refer to “SELECTING AND PROGRAM-
MING YOUR CODES” on page 7 for more information. (To perform this function, hold down
Key [8] until sounder beeps.)
6
