23
Scanner Settings
Scanner tab
The Scanner tab provides the following options:
Document Feeder
Paper Source
Automatic: looks for paper in the ADF first. If there are no documents in
the input elevator, the scanner will scan from the flatbed. This option is
only available if a flatbed is attached.
ADF: the input elevator is in the highest position. This selection is
recommended when you are scanning 25 sheets or less from the input
elevator.
Flatbed: scanner will scan from the flatbed.
This option is only available if
a flatbed is attached
.
Automatically start transport
— if selected, the scanner will wait for up to 10
seconds for documents to be placed in the input elevator before scanning will
begin. In addition, once the input elevator has been emptied, the scanner will
automatically resume scanning when paper is placed in the input elevator. The
scanner will wait the amount of time specified by the document feeder timeout.
Sheet Counter
— enter the number to be assigned to the next physical sheet of
paper entering the scanner. This is incremented sequentially by the scanner and
is returned in the image header.
Timeout
— allows you to set the amount of time the scanner will wait after the
last document enters the transport before the transport timeout action is taken.
You can specify a time delay setting from
1
to
120
seconds.
Response
— indicates the action that will be taken when the document feeder
timeout has been reached.
Stop Scanning: scanning will stop and control will return to the scanning
application (e.g., ends the job).
Pause Scanning: scanning will stop but the scanning application will be
waiting for additional images (e.g., stops the feeder). Scanning may be
resumed by pressing the Start/Pause button on the Operator Control
Panel. Scanning may be stopped by pressing the Stop button on the
Operator Control Panel or via the scanning application.
Pause Scanning - wait for Paper: scanning will stop but the scanning
application will be waiting for additional images (e.g., stops the feeder).
Scanning will be resumed automatically when documents are added to the
input elevator.
