Alamo Schwarze SUPERVA C SUPER UPDRAFT, Руководство по эксплуатации продукта

Страница: 68 / 79

Section 4 - Service
revised 04/19 SCHWARZE SUPER UPDRAFT
69
13.4 Hydraulic Filters
NOTE: Replace or clean the suction filter after the first 500 hours of operation, then every 2000 hours
thereafter.
Replacement:
1. Place a small tray or oil rag under filter before
removing.
2. Remove filter by rotating canister counter
clockwise.
3. Install new filter. Be sure to apply a small
amount of oil onto the filter gasket before
installation.
NOTE: Change the return filter after the first
500 hours of operation, then every 2000 hours
thereafter.
4. Remove the lower housing of the Pressure
Filter.
5. Fill the hydraulic tank following the procedures
outlined in ‘Hydraulic Tank Fill-up’.
6. Start the auxiliary engine and allow the fluid to
re-circulate through the system.
7. If needed, refill the reservoir to the full mark of
the site gauge.
13.5 Directional Valve Override
Your unit is equipped with manual overrides, which
can be used at any time if you blow a fuse or have
any other electrical problem. The overrides control
the gutter broom only.
The gutter broom override is located at the center of
each coil of the gutter broom valve. To manually
override the valve, use a small screw driver or
round pin to depress to center pin to shift valve.
One side of the valve lowers and the other side lifts.
Hydraulic Filters
Directional Valve Override