Alamo Schwarze SUPERVA C SUPER UPDRAFT, Руководство по эксплуатации продукта

Страница: 51 / 79

Section 3 - Operations
52 SCHWARZE SUPER UPDRAFT
revised 04/19
3.9 Dumping the Hopper
3.10 Quick Reference Operating Guideline
1. Check the truck engine and sweeper engine for the correct crankcase oil and coolant levels.
2. Fill the water storage tank.
3. Start the truck engine and check the control panel for the correct switch settings.
4. Insert the key, start the auxiliary engine and allow to warm up.
5. Before sweping, let the hydraulic oil warm-up to operating temperature.
6. Turn on the water fl ow valves.
7. Turn ‘ON’ all warning lights and fl ashers.
8. Lower the sweeping head to the pavement.
9. Activate the dust suppression system.
10. Turn ‘ON’ the gutter broom as needed to transfer debris from the gutter to under the sweeping head.
Dump the hopper when it is full, or after you have fi nished sweeping for the day. Always dump on level ground and never attempt to dump over
an open pit or dock. Before raising the hopper, check for overhead clearance restrictions, put the truck in ‘PARK’ and engage the emergency
brake.
Back the sweeper up to dumpster or other suitable dumping area.
The hopper dump control switch is located on the console. It is also the same switch used to raise and lower the head. It is a ‘MOMENTARY
ON/OFF / MOMENTARY ON’ switch. To raise the hopper, turn ignition switch on, push the switch into the ‘UP’ position, and hold it until the
hopper is completely raised. The hopper dump door will swing open and any debris will be dumped behind the sweeper. If equipped, the dump
door can be raised using the manual lift lever located on the right hand side of the hopper.
Before lowering the hopper remove the safety chocks, if used, and make certain the area under the hopper is clear. Hold the dump switch in
the ‘DOWN’ position to lower the hopper. This switch uses a spring-loaded momentary contact which will return to the ‘OFF’ position when
released.