Alamo Industrial Great White M8000MD, Руководство оператора

Страница: 61 / 86

MAINTENANCE
Maintenance Section 5-4
© 2004
Alamo Group Inc.
MAINTENANCE
M-8000MD 12/04
Follow these simple steps to tighten the main drive chain which runs in the oil bath reservoir. Remember: You do
not need to remove the reservoir cover to tighten the drive chain.
1. Locate the take-up bolt. This bolt is found on the right side of the blower, through the large hole in the side
shield. Inside the shield you will find a locking channel up, exposing the idler take-up bolt.
2. Using a torque wrench, tighten the take-up bolt by turning it clockwise to 9 ft. lbs. of torque. Turn bolt head
clockwise until the bolt head flats are parallel with the locking channel to slip back over the bolt head.
NOTE: Be sure to tighten the chain by following these instructions. The chain should be tightened after the first
10 hours of operation and ever 100 hours thereafter.
CHAIN TENSIONING INSTRUCTIONS
STORAGE
Wash any dirt or salt off the snow blower.
Smear grease over any exposed hydraulic cylinder rods.
Locking Channel
FIGURE 6
Tensioner Bolt
FIGURE 7
FIGURE 5