AL-MEISTER ALM3222 Instruction Manual <Rev.2>
Page
48
of
52
6. TROUBLESHOOTING
Problem
Check if:
Solution
Page
●Laminated sheet is not
discharged. On the display:
DISCHARGE ERROR or
LAMINATION ERROR,
Laminated paper is stuck in
the lamination section, the
trimmer section and/or the
cutter section.
[1]Open the Feeder cover. Cut the
upper and lower film just below
the guide roll. Turn the operation
lever to OPEN position. Hold the
cut film firmly. Pull it out toward
you. Press RESET button. When
the laminated sheet in the machine
cannot be taken out, and/or the
problem is not solved, turn off the
power and contact your dealer or
the Drylam Tech-Line.[2] Check if
the film waste is stuck in the
trimmer unit.[3] Open the trimmer
cover. Remove the film waste. [4]
To remove the film waste around
the cutter unit, first turn off the
power and pay attention not to
touch the cutter blade.
@The lamination rollers get very hot.
@ Be careful that your fingers or
clothes do not get caught in the
rollers.
@ Do not touch the cutter unit@ Do
not dismantle.
@ Be careful that your fingers do
not get cut.
S
ome useful tips.
•
Flatten the papers before
lamination.
•
If the laminated film has a
curl, adjust the film tension.
•
Empty
the
waste
box
periodically. The remaining
film waste in the waste box
may pile up and cause
problems around the trimmer
unit.
●CUTTING ERROR
Open the trimmer cover. Press
Manual Cut Switch. Press RESET
button. If the error is not solved,
please contact your dealer or the
Drylam Tech-Line. Do not touch
the cutter unit.
●FEEDING ERROR
More than two sheets are fed
at one time.
More than 4”of paper is being
fed.
Paper is thick and smooth on
its
surface
posing a
Remove the paper. Slightly raise
the position of Feeding Pressure
Knob. Flatten the papers. Ruffle
well. Press RESET button to clear
error.
