AL-MEISTER ALM3222 Instruction Manual <Rev.2>
Page
22
of
52
4. SET LAMINATION FILM/MANUAL MODE (cont’d)
If the threading card and film do not emerge from the discharge
within 5 seconds
pull the threading back out
of the nip and repeat the threading process from step 6.
If the machine is not threaded properly damage to
interior components will occur.
15. After most of the threading card and
film web emerge from the discharge lower
the Lamination Handle.
STOP! Do not go any further until the
READY light is on AND the machine is fully
heated.
16. It is very important to run the machine
in “manual mode” (using the MOVE
switch) and look at the film as it exits the
discharge. It should be well laminated
(clear) and free of wrinkles. If wrinkles are
observed adjust the tension controller
knobs slightly on the film rolls. If the film is
curled this could be an indication that the
tension of one of the film rolls is tighter
than the other. Film must exit the machine
flat, clear and free of wrinkles before being
put into automatic mode (pressing the
START button). If there is curl during
manual mode there may be curl during
automatic mode which will likely produce
errors and possibly damage interior
components the machine.
