b- CC-RELATIVE (ENC): Control Change messages are status 0xBn, where n is the
channel, for the specified CC controller. Thus the controller MIDI ID is indicated with the
channel along with the CC number. The value from 0x40 to indicate the change in the
controller. This is an offset to 0x40 “one's complement” notation.A message with data 0x43
indicates a positive change of 3. A messages with data 0x31 indicates a negative change of
15.
C- SWITCH ON/OFF (SW,CENTER,CW,CCW): These messages are used for
switches.Control Change messages are sent with status 0x9n, SWITCH On and Off value are
0x7F and 0x00, where n is the channel.
d- LED ON/OFF (LED): These messages are used for LED.Control Change messages are sent
with status 0x9n, LED On and Off value are 0x7F and 0x00, where n is the channel.
There are two ways of assigning DJ Software function to Kuro controls:
1- Us Kuro Internal Menu MIDI assign and MIDI MAP
2- Use DJ Software LEARN function
See the MIDI MAP at page
31
.
Bear in mind that is expressed in “Hexadecimal” base and also in “Decimal” base. You will have
to use the Decimal base at the DJ Software.
At page
32
you will find an explanation regarding the MIDI MAP and the MIDI address draw.
E - MIDI CONTROLLER
ENGLISH
30