Quick Start Guide
1. Step – Prepare Hardware
è
Connect the power supplies of the HUB4000 Q(s)
è
Connect the power supplies of your wireless devices
è
Connect the AKG devices (DSR700, SR4000/4500, SST4…) ‘data’ connectors
with one of the 8 HUB4000 Q ‘AKG network devices’ connectors (8 connectors
for 8 slots).
Use the RJ 11 cables which are included at the HUB4000 Q package.
à
you can connect up to 8 AKG devices to a HUB4000 Q
è
It is strongly recommended to use an
Ethernet DHCP router
in your HiQnet
network. If you connect a DHCP network router (which has a built in DHCP
server for automatic IP address management in your ethernet network) setting
up the system is much more easier and faster because you don‘t have to care
about IP addresses (that‘s done by the DHCP server inside your DHCP router).
è
Connect the Ethernet connector at the HUB4000 Q with the HiQnet ethernet
LAN (Local Area Network), e.g. if you have connected a DHCP router, with one
of the LAN ports of the DHCP router.
Depending on which monitoring (
System Architect
,
VM2
or
Wireless iPhone App
)
you want use connect one or multiple of the following with the HUB4000 Q:
è
Connect your Computer which should run
Harman System Architect
with the
HiQnet LAN, e.g. if you have connected a DHCP router/switch, with one of the
LAN ports of the DHCP router.
è
Connect a Vi console (with
VM2
)
ethernet port with the HiQnet LAN
è
Connect a WLAN (Wireless Local Area Network) router to the HiQnet LAN if you
want to use the
AKG Wireless iPhone App
2. Step – Perform Firmware Update - Harman System Architect
December 2012
Page 3
HUB4000 Q – Quickstart Guide
