Scope
5 (16)
Sesam 800 K3 RXDIN USA Manual
Document-ID: 946415-000
Version: A0
Author: SH
7. Radio controlled operators should always position themselves for the best
view of the equipment they are controlling. The equipment should never
be operated blindly. The operator should always remain at a safe distance,
without losing line of sight with the equipment.
8. Transmitter switches should never be mechanically blocked ON or OFF for
any equipment motion.
9. After daily operation, a secure storage space should be designated for the
transmitter unit especially when not in use. This precaution is intended to
prevent unauthorized use of the equipment.
10. The equipment operator should keep all body parts away from the door
they are controlling. Do not attempt to operate the system without checking
door for obstructions.
11. The equipment has been tested for correct operation before delivery from
the factory. However, it must not be used in critical or hazardous operation
where incorrect operation may cause personal or equipment damage. If the
equipment fails to respond or behaves improperly, the equipment operator
should NOT operate the equipment AND should notify his/her supervisor
immediately. When serious conditions are noticed (conditions that make
the equipment unsafe to operate), the equipment should be shut down im-
mediately and the supervisor notified.
WARNING:
SECURE THE WIRELESS REMOTE CONTROL TRANSMITTER PRIOR TO
PERFORMING ANY MAINTENANCE.
CAUTION:
THE RECEIVER UNIT OR RELAYS ARE NOT RATED AS EXPLOSION PROOF.
THE RECEIVER UNIT MUST NOT BE INSTALLED OR OPERATED IN EXPLOSIVE
ENVIRONMENTS UNLESS APPROPRIATE SECONDARY ENCLOSURE MEASURES
ARE TAKEN.
WARNING:
THE UNIT MUST BE WIRED TO THE CORRECT VOLTAGE; FAILURE TO DO SO
MAY DAMAGE THE SYSTEM.
