Indicators on the receiver
11 (16)
Sesam 800 K3 RXDIN USA Manual
Document-ID: 946415-000
Version: A0
Author: SH
7
Indicators on the receiver
The Sesam 800 RX DIN model has three LED indicators that is displaying
system information (see fig. 1 for positions of the LEDs).
The indications on the LEDs are as follows:
1.
LED 5 Squelch: Indicates a detected signal on the operating frequency
band.
2.
LED 6 Status: Indicates that information from a transmitter associated with
the receiver has been received.
3.
LED 7 Learn: Indicates if the transmitter is in Learn Mode.
8
Configuration of the receiver
8.1
Basic configuration
1. Open the lid on the receiver. Open the lid of the receiver by pressing the
snap fits on the sides with a screwdriver or similar and pull apart the cover.
2. Press the Learn/Erase button until LED 7 is ON. The Learn Mode
will be active for 10 seconds (as long as LED 7 is ON).
a. Transmitters Keyring K3: Press button 1 on the transmitter if buttons
1-3 shall be used for activating the relays in the receiver
3.
LED 7 on the receiver flashes 3 times if the Learn procedure is successful.
4. Mount the receiver cover by match top and bottom together and press, the
snap fits on the sides locks.
