AJA FS1, Инструкция по установке и эксплуатации

Страница: 108 / 140

98
6. In the web browser, changing this parameter will show/hide the Set Password and
Confirm Password controls for setting the password.
7. You may be prompted for a password before you are able to set a new password. In
this case, you need to enter the default password. (This happens because enabling
the feature enables it with the default password already set to “password” and all
traffic to/from the FS1 needs to be authenticated once this happens.)
Set Password— the field used to enter a password (this field will not be visible if
Authentication is set to Disabled).
Confirm Password and Change Password button— the field used to confirm the password
entered above; contents must match, and the password will not be final until the
Change Password button is clicked (these controls will not be visible if Authentication
is set to Disabled).
Display Intensity (70.2) —Either by using the slider or by entering a value, you can dim or
brighten the alphanumeric display and activity indicator LEDs in steps from 1 (dim) to
8 (brightest).
Reset All FS1 Parameters To Factory Values (99.0) —As this button title implies, clicking it
will cause all current FS1 parameter settings to revert to the original AJA factory
values (except network settings—which are retained). Any settings you have made
to date will be overwritten.
Recalling factory defaults does not affect these network settings: IP Config , IP Address ,
Subnet Mask , or Default Gateway . To clear network settings and recall factory defaults,
hold down both Adjust buttons at the same time from the FS1 front panel.