paying close attention to orientation. Then glue the base down.
47) Clean any excess epoxy using a paper towel soaked with denatured alcohol and set aside to cure.
48) Attach 6” servo extensions onto the servo leads and using the string inside the wing tape the extension to the string and pull
the extension through the wing.
49) Install the servo into the wing utilizing the hardware that came with the servos. Then install a 1.25” servo arm so it is roughly
perpendicular to the servo case.
50) As with the other control arms, attach the ball link to the control horn with washers and a nylon nut, thread on the turnbuckle
and a ball link on the other side. Secure to the servo arm and adjust the turnbuckle until the surfaces are level.
51) Repeat on the other wing.
