Airwell KCD, Руководство по установке

Страница: 21 / 144

11. PANEL INSTALLING
Removing the
grille:
1. Push two grill switches to the direction at the same time,and then pull them up. (Fig.22)
2. Draw the grill up to an angle of about 45, and remove it.(Fig.23)
Fig.22
Fig.23
Remove the corner covers(For model 24-48)
Wrench off the bolts, loose the rope of the
installation covers,and remove them. (Fig.24)
Install the panel
For Model 09-18:
1. Align the swing motor on the panel to the
tubing joints of the body properly.(Fig.25)
2. Hang the four fixed rope of the main body
to the installation cover and the other three
covers of the swing motor.(Fig.25)
3. Install the panel on the main body with bolt
(M5×16) and washer.
4. Adjust the 4 blots to keep the panel horizontal,
Close the bolts until thickness of the sponge between
the body and the panel has been reduced to about
4~6mm. (Fig.27)
Fig.24
Fig.25
20
Grill switch
Grill switch
Model:09/12/18
Model:24/30/36/42/48
Drain side
Bolt, washer x4
For Model 24-48:
1. Align the swing motor on the panel to the tubing joints of the body properly.(Fig.26)
2. Fix hooks of the panel at swing motor and its opposite sides to the hooks of
corresponding water receiver. (Fig.26-1)
3. Hang the other two panel hooks onto corresponding hangers of the body. (Fig26-2)
4. Adjust the four panel hook screws to keep the panel horizontal, and screw them up to the
ceiling evenly.(Fig.26-3)
5. Regulate the panel in the direction of the arrow in Fig.26-4 slightly to fit the panel's center
to the center of the ceiling's opening.
Guarantee that hooks of four corners are fixed well.
6. Close the bolts under the panel hooks, until the thickness of the sponge between the body and
the panel has been reduced to about 4~6mm. (Fig.27)
ENGLISH
Indoor unit cassette type