Manual Configuration of SpectraGuard Sensor
SpectraGuard Sensor Installation Guide
11
4.
Change Discovery Settings
Manual configuration can be done through a Web Interface (http) or Command Line Interface
(CLI).
5.3
Configuring SpectraGuard Sensor through Web Interface (http)
Configuration using Web Interface is done using the network connection or using the crossover
cable connected between your machine and the Sensor.
Figure 6 Connecting to SpectraGuard Sensor using the Crossover Cable
Important!
For Web configuration using the crossover cable, make sure that your machine is not running a
DHCP Server. You can figure this out by looking at the SpectraGuard Sensor LEDs. If LED1 is yellow and
LED2 is Fast Blinking Green, it means that Sensor did not get an IP address from the DHCP Server. In that
case, the SpectraGuard Sensor network settings would default to the following:
IP Address: 192.168.1.245
Network Mask: 255.255.255.0
The steps to configure SpectraGuard Sensor using Web Interface are explained in detail below.
5.3.1
Step1: Log into the Web Interface
You have to log into the Web Interface to configure the SpectraGuard Sensor.
Содержание SpectraGuard Sensor
Страница 1: ...SpectraGuard Sensor InstallationGuide ...