- 69 -
1. Apply Molykote PG-662 to the Sleeve B and Cutter Ring of the Arm Shaft Assy., and the Cutter
Lever of the Arm B Assy. as shown in the figure.
2. Apply Molykote PG-662 to the gear section of the Motor Gear B unit and put it in between the
Planetary Gears B.
3. Connect the 3P of the Harness 11P unit to the Sensor Board A unit, and the 5P to the Sensor Board
B unit.
4. As shown in the figure, put the 3P and 5P of the harnesses through the Arm Shaft Guide and the
notch
of the Frame L.
When assembling the Arm Shaft Guide to the Frame L, block the notch
with the Arm Shaft Guide
so that the harnesses will not float.
5. Assemble the Arm Shaft Assy. to the Frame L.
Fit the Sleeve Guide, Arm Shaft Guide, Internal Gear B and Motor Gear B unit into the ribs of the
Frame L.
Fit the straight section of the Cutter Ring into the groove in the Wire Guide Lever. Put the L-bent
section in between the two levers of the Cutter Lever.
After assembling, make sure that the harnesses are not caught between the cylindrical section of the
Internal Gear B and the ribs of the Frame L, and that the front angular form of the Internal Gear B is
firmly fit into the ribs of the Frame L.
6. Connect the Harness 3P unit to the Sensor Board B Unit.
7. Make sure that the Sleeve Guide of the Arm Shaft Assy., Arm Shaft Guide, Internal Gear B and
Motor Gear B Unit are fit into the ribs of the Frame, and that the Cutter Ring is fit into the Wire Guide
Lever.
ASSEMBLY PROCEDURE
