AirMan PDS400S-6E1, Инструкция по эксплуатации, Страница: 63 / 89

5.Periodic inspection/Maintenance
5-11
5.5.7 Change compressor oil filter element
At 300 hours for the first change and every 500 hours thereafter
Be sure to use genuine filter element.
＜
Procedure
＞
1. Remove the oil filter element [A], using a filter wrench.
2. Screw in the new oil filter element [A] with the packing
[B] coated slightly with oil.
(For part number, See 5.4)
3. After the packing touches the sealing face, tighten
another
1/2 to 3/4 turn with a filter wrench.
4. After installing the oil filter element, check it for any
leak during operation.

Poor quality oil filter elements do not trap dust sufficiently and will cause damage to
the bearings in a short period. Be sure to use genuine parts.
5.5.8 Change air filter element
Every 500 hours
Be sure to use genuine air filter element.
<Procedure>
1. Loosen the cap fix latch [B] at cap [A], then remove cap
and clean inside.
2. Remove element [C] & [D] and replace it with new one.
(For part number, See 5.4)
3. When putting cap after replacing, push it into case [E]
with your hand and fasten it after checking the hook of
cap fix latch is set to case.

When used or operated under bad conditions, it is
better to remove all the elements, check them, clean
them and replace them earlier before the intervals
listed in maintenance table, if they are found difficult
to be repaired.

Air filter is an important part which is crucial to machine's performance and life.
Be sure to use genuine parts.
H000049
B
A
A150824
E
For engine
For compressor
D
B
A
E
C
B A
Go
to
Discount-Equipment.com
to
order
your
parts