AirMan PDS400S-6E1, Инструкция по эксплуатации

Страница: 61 / 89

5.Periodic inspection/Maintenance
5-9
[How to use booster cable]
<Procedure for using a booster cable>
1. Stop the engine.
2. Connect one end of the (+) booster cable to the (+)
terminal of the machine battery.
3. Connect the other end of the (+) booster cable to the (+)
terminal of the external battery.
4. Connect one end of the (–) booster cable to the (–)
terminal of the external battery.
5. Connect the other end of the (–) booster cable to the
engine block of the machine.
6. Start up the engine.
7. Disconnect the booster cable by following the procedure
back in the reverse order.

When a booster cable has to be used or when cables are connected again after an
battery is replaced, be careful not to connect (+) and (–) terminals backwards.
Such wrong-connection will cause spark and damage to each component.
5.5.5 Check and clean clogging of air filter element
Every 250 hours
<Procedure>
1. Loosen the cap fix latch [B] at cap [A], then remove cap
and clean inside.
2. Remove the element [C] & [D], and clean it.
3. When putting cap after cleaning, push it into case [E]
with your hand and fasten it after checking the hook of
cap fix latch is set to case.

If the element is found heavily dusty, replace it with a
new one.
(For part number, See 5.4)

When an element that is clogged or has holes or cracks is used, dust or foreign
material will get in the engine. This causes accelerated wear in each sliding part of
the engine. Be sure to make daily check and cleaning so that the life of the engine
will not be shortened
.
A150824
E
For engine
For compressor
A180126
Machine battery
External battery (12V)
Connect to the engine block
of the machine
D
B
A
E
C
B A
Go
to
Discount-Equipment.com
to
order
your
parts