[email protected] | www.airgain.com | + 1-855-AIRGAIN
10
5. Installing the Ethernet Injector
1. Record the Serial Number and Password from the back of the Ethernet Injector along
with a unique identifier for the vehicle. Save for your records.
*The serial number is required for software upgrades.
*The password is required to access the configuration interface of the Ethernet
Injector.
2. Locate a spot in the vehicle where the Ethernet Injector can be securely mounted.
The Ethernet Injector is an ESD and EMI sensitive device. Placement is important for
proper operation.
a. Do not mount on other electronics
b. Do not mount on carpet
c. Do not use velcro
3. Orient the Ethernet Injector so that the status LED can be viewed post installation
4. Follow either of the 2 recommended grounding methods
a. Method #1: Grounding via the supplied ground wire
(Figure 3)
1. Use the provided grounding wire or an equivalent with terminated
connectors matching assembly requirements; 14AWG or thicker gauge
and a max length of 2 feet. Confirm that the grounding wire is attached
to the screw in the Signal Conditioner.
2. If needed, add the grounding wire by removing the screw then sliding on
the loop terminal
3. Locate a grounding point inside the vehicle within reach of the grounding
wire
4. Secure the loose end of the grounding wire to the vehicle chassis
5. Use the supplied screws to secure the Ethernet Injector through the
mounting tabs
