EN
13
www.airfonix.com
Pairing Transmitters and Receivers: Setup Sequence
Step 1
Step 5
Step 2
Step 6
Step 3
Step 4
The ID code has now been copied to each of
the units and they are paired together. Follow
the instructions for Setting Zone Codes for
your installation on page 14 to complete setup.
NOTE:
The
LINK
LEDs on all paired units will
light green AFTER you have set the zone codes
and all units are powered ON again.
Setting
OFF
ON
Setting
OFF
ON
Transmitter
Transmitter
Transmitter
Transmitter
Receiver(s)
Receiver(s)
Receiver(s)
Receiver(s)
Receiver(s)
For all
receivers
: Push the third
dip switch to ON position to
enter pairing mode.
For all
receivers
: Push the
third dip switch to OFF
position to exit pairing mode.
Press the
PWR
button on
transmitter
to power ON.
With the remote pointing at the
transmitter
, press the
PAIRING
button. Watch the
LINK
LEDs.
The
•
transmitter LINK
LED flashes for three
seconds and then turns OFF.
The
•
receiver(s) LINK
LED light for one second and
then turn OFF.
Connect the power for all units.
DC IN
9V
Setting
OFF
ON
DC IN
9V
Setting
OFF
ON
LINK
Po
we
r
M
ut
e
So
ur
ce
Pa
iri
ng
Vo
l
-
Vo
l
+
Press PAIRING
LINK
PWR
IMPORTANT:
Before you begin, follow the sequence of six steps to PAIR each of the receivers
with the transmitter in your installation. You may pair one transmitter with up to two receivers.
You will need the remote control and a small screwdriver for these steps.
!
IMPORTANT:
Complete steps 3 and 4
within 10 seconds. Watch the LINK LEDs
to make sure the pairing is successful.
!
For
transmitter:
All dip switches
must be in OFF
position
.
Receivers
are in
pairing mode.
PWR
LED lights orange.
Setting
OFF
ON
Transmitter
For
transmitter:
All dip switches
must be in OFF
position
.
Setting
OFF
ON
Before You Begin
Press PWR twice
LINK
PWR
lights green
PWR
LED
LINK
PWR
PWR
LED
lights orange.
