Ibis 3 Owners Guide
Revision V1
Page
11
of
19
COMMISSIONING OF THE UNIT
Turn the power on at the circuit breaker.
Using the remote control (Item #6) press the
ON/OFF button.
Figure 17
. Each command from
the remote control should be answered by a ‘beep’
from the receiver in the plenum.
Figure 17 - Turn unit on
Press the MODE button until FAN mode is
selected.
Figure 18
Figure 18 - Select FAN mode
Press the FAN button to cycle through High
–
Medium
– Low fan speeds.
Figure 19
. Note air
flow as the speeds change.
Figure 19 - Change fan speed
Press MODE button until COOL is selected.
Figure 20
Figure 20 - Select COOL mode
Decrease the set point temperature below the
room temperature by pressing the
TEMPERATURE DOWN button.
Figure 21
. The
compressor will start within three minutes. Run unit
until you can feel cool air from plenum outlets.
Figure 21 - Decrease SET POINT temperature
Note:
Regardless of the mode selected there will
always be a delay before the compressor starts. This
delay is to protect the compressor and cannot be over
ridden.
Set mode to HEAT, and increase the set point
temperature above the room temperature.
Figure
22
. After the protection delay the compressor will
start.
Figure 22 - Change to HEAT mode and increase SET
POINT
